- Nrg quick release kit spin install#
- Nrg quick release kit spin update#
- Nrg quick release kit spin driver#
Reviving this old topic to ask a question.
Nrg quick release kit spin update#
Hope this helps, I will update as needed: Place the steering wheel up and line up the holes, place in the screws and whaalllaaa!! dont forget, depending on the horn button, there is a round metal piece that comes with the NRG Quick release kit that may be required to keep horn in place on the steering wheel. Once the bottom hub is on, you can now hook up the horn from the steering wheel. Now you want to place the bolt back on the steering column and tighten down real tight and then place the "D" pin back on over the bolt area.Īlso, do not forget to solder and cover the positive horn wire with heat shrink. Be sure to tuck all the wires in and now bolt the quick release bottom section onto the short hub. Now you want to place the spring in the hub hole where the aluminum piece was that you took out for horn supression, this will keep the wire in contact with the positive (+) connection. Here you want to take the NRG Short Hub (short hub #170) and place it on the steering column with the NRG on the top sideĪt this time you can go ahead and hook up the negative wire for the horn to the quick realse hub that connects to the main hub that you just put on steering wheel. Take a wire and fix it to the BOTTOM of the spring and slide the black pin back over top (hold on to this for late use). You will want to take the aluminum pin out by twisting the black pin (carefull it does have a spring behind it). When the steering wheel is off, it should look like this: Use a wrench or socket to press and pull off the steering wheel. Place the center of the remover kit with the threaded bolts already in the sides of the center bracket then use the threaded bolts on the remover kit and place in holes (there are two just alike on the steering wheel center).
Nrg quick release kit spin driver#
Use a flat head screw driver to take off the pin just above the 13/16th bolt, and then take off the bolt.
Take off the horn pad using a flat head screw driver and pry from the side (there is a small opening if you look for and it should just pop off). (These can be purchased at any local auto store) You need to take off the current steering wheel on you Fiero with the steering wheel remover kit. NRG second generation Quick Release #srk-200 (cbk) - (the cbk stands for carbon/black)
Nrg quick release kit spin install#
Since I was having yet another hard time finding the correct way to install after market steering wheels and short hubs with quick releases on Fieros and still keep your horn I thought I would do another write up.
0 kommentar(er)
